Omaha metro radon levels by county: the 2019-2024 state data
Most radon pages lean on the EPA's 1993 zone map and a state survey from 1989-1990. This metro has something better: the Nebraska DHHS Radon Measurement Report published in January 2025, which tabulates pre-mitigation test results statewide from October 2019 through September 2024. These are recent measurements from real Nebraska homes, taken before any mitigation, which makes them the most honest picture available of what an untreated house here tends to read.
The two layers agree with each other. The EPA maps Douglas, Sarpy, Washington, and the rest of eastern Nebraska in Radon Zone 1, its highest-potential tier, and the old survey found about 54 percent of Nebraska single-family homes above 4 pCi/L with a 5.5 statewide average. The fresh county table then puts numbers on the metro specifically, and every row lands at or above the EPA action level.
What no table does is measure your address. Averages describe counties; foundations, sumps, and soil pockets decide houses. Use the rows below to set expectations, then test the lowest level you actually use in Omaha or any of the towns around it.
| County | Recent average and EPA zone | What it means locally |
|---|---|---|
| Douglas County, NE | 4.8 pCi/L avg, 19,027 tests / Zone 1 | The metro core: Omaha, Millard, Elkhorn, Ralston, Bennington, Valley. The largest county dataset in the state, averaging above the 4.0 action level before mitigation. |
| Sarpy County, NE | 5.3 pCi/L avg, 5,649 tests / Zone 1 | Bellevue, Papillion, La Vista, Gretna, Springfield. Runs hotter than Douglas on average despite newer housing stock, a reminder that tight new basements still sit on the same soils. |
| Washington County, NE | Ring counties 5.3-8.0 pCi/L / Zone 1 | Blair and the bluffs north of the metro. The state table shows the ring counties around Omaha averaging between 5.3 and 8.0, all above the action level. |
| Pottawattamie County, IA | EPA Zone 1 | Council Bluffs. Every Iowa county is mapped Zone 1, and the loess bluffs share the Nebraska side's geology. Radon work here runs under Iowa Code chapter 136B with Iowa HHS certification. |
| Statewide, 1989-1990 survey | 5.5 pCi/L avg, 54% above 4.0 | The older baseline, date-stamped on purpose: a generation of retests has not changed the conclusion that most Nebraska homes deserve a test. |
| For scale: US averages | Indoor 1.3 pCi/L, outdoor 0.4 | EPA national figures. The metro's county averages run three to six times the national indoor average. |
The next step is identical in every row: test. A $15 to $30 kit placed on the lowest lived-in level, with the house closed for twelve hours beforehand, answers the screening question; a licensed measurement answers the contractual one. At 4.0 pCi/L or higher the EPA says fix the home, and between 2.0 and 4.0 it recommends considering it.
For what a fix costs by foundation type, see the cost guide. For the geology behind these numbers, read why the loess hills test hot.
Data sources
Ready to get started?
Douglas County homes averaged 4. Mon-Sat 8am-7pm CT.