Passive vs Active Radon Systems
New subdivisions across Elkhorn, Gretna, Bennington, and Papillion regularly include a builder-installed radon rough-in: a vertical pipe from under the slab through the roof, no fan. The question for thousands of metro homeowners is whether that passive pipe is enough or whether it needs a fan to become an active system. The honest answer depends on a test, because the two setups perform very differently.
Passive vs Active Radon Systems
New subdivisions across Elkhorn, Gretna, Bennington, and Papillion regularly include a builder-installed radon rough-in: a vertical pipe from under the slab through the roof, no fan. The question for thousands of metro homeowners is whether that passive pipe is enough or whether it needs a fan to become an active system. The honest answer depends on a test, because the two setups perform very differently.
| Feature | Passive (pipe only) The builder rough-in, driven by natural stack effect | Active (pipe plus fan) The proven fix, driven by a continuously running fan |
|---|---|---|
| How it moves gas | Warm-air buoyancy in the pipe, no powered draw | An inline fan holds constant suction under the slab |
| Typical reduction | Roughly 30 to 70 percent, per EPA guidance | Roughly 50 to 99 percent, per EPA guidance |
| Where it stands in the metro | Common in post-2000 Elkhorn, Gretna, and Bennington homes | The standard result after any elevated test |
| Monitoring | None; nothing shows whether it is doing anything | A manometer marked at start-up shows suction at a glance |
| Cost to get there | Already in the house if the builder ran it | Activating a correct rough-in runs $650-$1,200; a full system $1,200-$2,500 |
| Operating cost | Nothing | A small continuous electrical draw, stated before you sign |
| What can go wrong | Pipes that stop in the attic, miss the gravel layer, or were never sealed | Fans wear out over years and get replaced like any appliance |
| When it is enough | Only when a proper test of the finished house reads low | Whenever a test reads 4.0 pCi/L or higher |
Our recommendation
Test first, always. A passive pipe is a head start, not a result: if the finished house tests under the action level, leave it alone and retest every two years. If the house reads 4.0 pCi/L or higher, have a licensed specialist verify the rough-in actually reaches the sub-slab gravel and terminates correctly, then add the fan. When the builder pipe was done right, activation is the cheapest system on the price list; when it was not, a conventional system beats forcing a bad rough-in to work.
Ready to get started?
Douglas County homes averaged 4. Mon-Sat 8am-7pm CT.